If it’s not working check if something is wrong with the connections on the cables. Turn on the ignition to test the LED light. You will not be able to replace the fuse box cover due to the extender protruding out but you can not see it unless you have your head in the foot well. Note: The Suzuki fuse you remove will not fit into the Mini Blade Add a Fuse which is why you need to buy two 5 amp fuses that are made to fit whichever circuit extender you purchase. You now have a fused circuit with TWO 5 AMP fuses. Insert two 5 AMP fuses into the black connector on the Mini Blade Add a Fuse and push it into the slot where you removed the single 5 AMP fuse. ![]() Trim the red cable to allow enough length to reach the fuse box.Ĭonnect the red cable to the red cable of the Mini Blade Add a Fuse. Remove the 5 AMP fuse from fuse box in the location shown below in a red box. Attach a ring connector to the black cable then secure it to the earthing point. You can see I ran my cables down the right in the picture below. Trim the black cable to allow for enough length to reach the earthing point circled in red below. I unhooked the glove box (which is a total pain in the ass) to gain access to behind the dashboard to cable tie the wires easier. I ran my cables along the bottom of the glove box out of sight. Use some cable ties to secure the cables until you reach the far side of the passenger footwell. You can see the red and black cables on the picture below. I used duct tape.įeed the two cables under the trim leading towards the fuse box in the passenger side foot well. You want the LED to cover the white plastic. Then fix the light, face up onto the underside of the gear shift position trim. Matching the corresponding coloured cables if you’re a fanny like me. Remove the black cover from the fuse box and set this aside.Įxtend the cables on the LED Strip Light with the two 100cm cables. Remove the curved black trim below the fuse box. It’s easier remove if you pop the end of the door side step up to help pull this trim out. Remove the trim from the side of the footwell by unscrewing the plastic clip circled in red. This part won’t come off entirely so you have to leave it hanging loose. Unclip the trim that has the gear shift position writing on. You remove the plastic trim box by lifting up and angling it towards the dashboard. They simply pop out with a flat head screwdriver or trim removal tool. Remove the 4 clips on the gearbox trim, found on all four corners. ![]() You will hopefully have most if these items in your tool boxes, so it could be a super cheap mod. Or whatever else you have lying around to connect the wires up. Use whatever you want, I had some already in RED & Black
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |